_
B&P ENGINEERING GROUP
pl en de
Feed screws

Feed screws

The device is intended for horizontal and vertical transport of pomace.


Working screw diameter     200, 250, 300, 350, 400, 500 mm
Screw type clockwise and anti-clockwise
Screw rotary speed              40 - 112 rpm
Screw length                               1; 2; 2,5; 3 m
Working trough length           according to the customer requirement
Drive motor power                 0,75 - 18,5 kW
Capacity   up to 50 m3/h
Total length     to be argeed
Two types are available:
  • Closed pipe-type feed screw
  • U-type trough feed screw

The U-type trough feed screw is open at the top. It comes in two variants: with or without a cover. The U-type trough feed screws also include discharge baskets fitted with an extended charge and a screw in the bottom section. The U-type trough feed screws can be fitted with a heating or cooling jacket.

Feed screw can be installed on a support structure permanently attached to the ground or be equipped with casters for transport. The class of the material the machine is made of depends on its intended purpose. For the food industry, the machine is made of acid- proof material and plastic materials approved for contact with food. Non-alloy steel elements are covered with an anti-corrosive coat.

 

The closed pipe-type feed screw is a pipe with a shaft inside with welded screw blades and passive bearing. The screw’s blades have different pitch, depending on the type of the transported raw material and the planned capacity. This type of conveyor is closed, which means that the screw cannot be accessed directly. Thanks to the closed structure, the transported raw material does not spill outside the machine during transport. The machine can be equipped with a pull screw. In this version, the drive unit is located on the raw material feeding. Some feed screwsare equipped with push screws with gear motor installed on the feeding side. The feed screw is fitted with an initial or end bearing. Depending on the type of transported raw material, slide or bearing rests are installed. When required by the customer, the screw feed can be fitted with a washing system in the spindle. This enables washing the feed from the inside, eliminating the need to dismantle it.

Complete lines for production of juices and concentrates
Complete lines for production of juices and concentrates
Feed screw
Feed screw
Contact with Specialist

Fill the form

Name, lastname
Email address
Preferred method of contact
    

Contact phone
Message
Attach file (max: 64Mb)